Water softener size calculator

Three steps, instant answer. The math is shown, the sources are linked, and nothing leaves your browser.

  1. 1Household
  2. 2Your water
  3. 3Your result

Who uses the water?

Count everyone who lives in the home most of the time.
Advanced: daily water use and salt price
Default 75. EPA WaterSense reports the average American uses roughly 82 gallons a day at home; lower it for a frugal household.
An editable assumption used only for the annual cost estimate.
Fill in the fields for an instant estimate.
Planning estimates only. Verify your numbers with a certified lab test, and have any installation done by a licensed plumber. Results are estimates, not engineering, plumbing, medical, or legal advice, and no health claims are made. See the terms.

Learn how the result is calculated

Four steps, shown in your result

  1. Compensated hardness. Hardness plus 3 gpg per 1 ppm of iron.
  2. Grains per day. Compensated hardness × gallons used per day (people × 75 by default).
  3. Capacity. Grains per day × 7 days, rounded up to the next standard size: 24,000, 32,000, 48,000 or 64,000 grains.
  4. Regeneration and salt. Size ÷ grains per day gives days between regenerations; grains per day × 365 ÷ 3,350 grains per lb gives salt per year.

Source: USGS Water Science School: Hardness of Water Source: NSF/ANSI 44: Residential cation exchange water softeners (NSF)

Is my water hard?

Hardness (gpg)Categorymg/L (approx.)
Under 1Softunder 17
1 to 3.5Slightly hard17 to 60
3.5 to 7Moderately hard60 to 120
7 to 10.5Hard120 to 180
Over 10.5Very hardover 180

This is the grains-per-gallon scale commonly used in the water-treatment industry. USGS publishes a similar scale in mg/L with slightly different category names; both describe the same calcium and magnesium minerals. Source: USGS Water Science School: Hardness of Water

Frequently asked questions

How do I know my water hardness?

Check your utility's annual Consumer Confidence Report, use the hardness lookup for an approximate figure for major metro areas, or send a sample to a certified lab. Test strips give a rough number only. Private wells always need their own test.

Why does iron change the softener size?

Iron occupies the same resin sites as hardness minerals, so sizing practice adds about 3 gpg for every 1 ppm of iron. Above roughly 2 ppm, an iron filter ahead of the softener is the usual plan.

Why a 7-day regeneration target?

A softener sized to run about a week between regenerations balances salt efficiency against unit size. Larger sizes regenerate less often; smaller ones more often but are sized correctly if the interval stays reasonable.

Can I pick a smaller size than recommended?

You can, but the unit then regenerates more often and uses more water and salt for the same hardness. Going one size up costs little and gives headroom for guests or higher hardness.

Is my result a quote or professional advice?

No. It is a planning estimate. Verify with a certified lab test and have installation done by a licensed plumber.

Sources